BY-1303 release film cleaning agent
In view of the cleaning of the phosphating film remaining on the inner surface of the cold-rolled steel pipe and the impurities carbonized by high temperature during cold rolling, our company draws on the advanced technology formula from home and abroad and uses BY-1303 degreasing agent developed and produced by high-quality raw materials. crafting process:
1) BY-1303 cleaning
2) 2 washes
3) Post processing
Process parameters:
1) Distribution tank concentration: 5-10%
2) bath temperature: 50-85 degrees
3) Processing time: 3-15 minutes
4) Spray pressure: 1-1.2
5) Free alkalinity: working fluid 40-80 points
Distribution method:
Add 75% cold water to the tank, add appropriate amount of the agent and mix well, then add water to the working level and heat to the operating temperature.
main feature:
1) The use of the agent has low cost, good effect, fast speed and long service life.
2) The preparation is not water quality, low foam, non-toxic, non-combustible, non-explosive, safe to use.
3) It can be used as an alkaline rust remover for the removal of yellow rust on steel surfaces.
4) The degreaser is compounded by a non-ionic surfactant, has excellent emulsification, penetration, wetting and degreasing ability, is easy to clean, and does not cause lacquer pitting, shrinkage, pits and the like.
5) It can be used for spray cleaning, and the distribution tank is 1-5%.
Control maintenance:
1) With the continuous operation of the bath, the free alkalinity will gradually decrease, and the BY-1303 type skim powder should be measured and supplemented regularly. Generally, 1.5 kg of BY-1303 type skim powder is added, and the free alkalinity is increased by 1 point.
2) After a certain period of use tank failure, discharge re-distribution is required.
3) Prepare ultrasonic cleaning, which will be better for complex long and short workpieces.
4) Before the processed workpiece is transferred to the next process, it should be cleaned in flowing clean water.
5) Pay attention to the oil and dirt in the liquid surface to prevent the workpiece from being contaminated again.
Precautions:
1) Store in a closed bag and store in a dry place.
2) Stored in the original packaging, this product is valid for one year.
[-1-]